1. Planning and Taking Measurements
Planning is very important before starting any installation. Start by getting the right measurements for the area. This step makes sure you buy the right amount of marble and cuts down on waste. Next, think about what kind of marble you want: polished, honed, or textured. Each finish looks and works differently.
A flat and stable surface is very important. It’s important to check the substrate and get it ready because uneven floors or walls can cause cracks or misalignment.
2. Getting the surface ready
Preparing the surface correctly will make sure that your marble lasts. Get rid of any dust, grease, or old glue in the area. Use a leveling compound if the floor or wall isn’t level. Applying a waterproof membrane is highly recommended in wet areas like kitchens and bathrooms to keep moisture from damaging the surface.
Professional jasa pasang marmer always stress this step because a clean and level surface is the key to a successful installation.
3. Planning and Dry Layout
Set up the marble slabs in a dry layout before using any glue. This lets you see the final pattern, line up the veins, and make plans for cuts around edges or other things in the way. Use chalk lines to mark guidelines so that everything is straight and even. Taking your time at this point will help you avoid mistakes and patterns that don’t match up later.
4. Putting on the glue
It’s important to pick the right glue if you want your results to last. A thin-set mortar is common for floors, but epoxy adhesives work best on heavy slabs and countertops. Use a notched trowel to spread the glue evenly. For big pieces of marble, put a thin layer on the back as well. This is a trick that professional jasa pasang marmer use to give the marble more support.
5. Putting in Marble Slabs
Put each marble slab carefully on the glue. Use spacers to keep the gaps between the tiles even for grouting. Use a spirit level often to make sure the surface stays flat and straight. At this point, being precise makes sure the finish looks professional and stops problems from happening later.
6. Cutting and fitting
Some parts will need to be cut to fit around edges, corners, or things in the way. Before cutting, make sure to measure carefully. Use the right tools, like a wet saw or diamond blade, to get clean cuts and keep the marble from chipping.
7. Grouting
It’s time to fill the joints after the glue has dried. Choose a grout color that goes well with your marble. Use a rubber float to spread the grout evenly and push it into the gaps. Wipe off any extra right away so that it doesn’t harden on the marble surface.
8. Sealing and polishing
For both protection and looks, polishing and sealing are very important steps. Using a good sealant keeps marble from getting stains and moisture. Polishing brings out the marble’s full beauty by enhancing its natural shine and veining. It is best to have professional jasa poles marmer polish your floors every so often to keep them looking good for a long time.
9. Final Cleaning and Inspection
Check the marble carefully after it has been put in place. Look at the alignment, joints, and finish on the surface. Get rid of any leftover stuff and buff the surface to make it look smooth and shiny. Your marble installation will look beautiful and last for years if you take care of it properly.